Frigidaire A01060901 Manual De Propietario

6

To Level the Appliance:
While unit is laying on its back, note the location 

of the 4 leg levelers installed at each corner.  

These leg levelers will be used to level the unit 

and to adjust the height. Use a carpenter’s level 

to level the appliance from front to back and side 

to side. Adjust the plastic leveling feet in front, 

½ bubble higher, so that the door closes easily 

when left halfway open.



All set screws should be tightened and sub-

flush (Allen set screw should be seated just 

below the surface of the end cap) of handle 

end cap.  The end caps should be drawn tight 

to door with no gaps.

2. Position handle end caps over upper and 

lower pre-installed shoulder bolts (A) that 

are fastened into door, ensuring the holes 

for the set screws are facing towards the 

outside of door if a single unit installation 

or the refrigerator door (if installing the 

matching refrigerator). 

3. While holding handle firmly against door, 

fasten upper and lower Allen set screws (B) 

with supplied Allen wrench. 

4. Repeat steps 2 and 3 to install handle (if 

installing the matching refrigerator).  Ensure 

the holes for the set screws are facing 

towards the refrigerator door.

•  Level door of first unit using all four levelers 

and slide unit into place. Recheck for 

levelness and adjust if necessary.

•  Measure distance from floor to bottom of 

door on first unit.  Adjust and level second 

unit so door height matches. 

  Leg Level Adjustments:

•  One full turn of all four leg levelers will raise 

door 5/32”.

•  Slide second unit into place leaving a 

minimum gap of 3/16” between units for 

door swing clearance.

•  This last step may require at least one 

extraction of the second unit to properly 

align units in a “built-in” application.

To remove the kick plate, use a Phillips head 

screwdriver and remove the two screws holding 

the kick plate to the cabinet.  Then pull the kick 

plate away from the unit.

Rest all bottom corners firmly on a solid floor.
The floor must be strong enough to support a 

fully loaded appliance.  
It is VERY IMPORTANT for your unit to be level 

in order to function properly.  If the appliance is 

not leveled during installation, the door may be 

misaligned and not close or seal properly, causing 

cooling, frost or moisture problems.

A

B