Continental Refrigerator Undercounter Refrigerator and Freezer Pizza Preparation Table Manual De Usuario

Your new “SW” series model is supplied with adjustable type legs for leveling 
purposes. Each SW27, SW48, SW60 and SW72 model has four leg mounting 
holes on its case bottom. Legs are packed in the accessory carton from which 
they must be removed and installed on the cabinet case bottom (see figure 2). 
In order to install the legs, carefully tip the cabinet rearward adding four (4) 2" 
wood blocks underneath and simply screw the threaded leg studs into the case 
bottom front leg holes. Repeat this procedure by tilting the cabinet in the opposite
direction and install the remaining legs. Make sure the legs are tightened extremely
well or the entire model will sway or rock with each opening or closing of the doors,
possibly causing damage to the case bottom. This procedure should be performed
close to the final installation site and allow access to the rear of the cabinet for 
condensate evaporator installation (see “condensate evaporator installation” under
installation and location section).

To assure your cabinet is level, all legs are equipped with bullet-type leveling bolts.
These bolts can be turned by hand or by wrench, clockwise or counterclockwise to
level the cabinet.

7