Continental Refrigerator Refrigerators and Freezers Manual De Usuario

cleaning may result in a streaking or staining of the metal. 
 
Complete cleaning procedures and precautions are listed in the "periodic cleaning 
procedure" under the maintenance section. 
 
 
 
 
 
 

To insure proper operation, your new model must be connected to an individual 
circuit that can supply the full voltage as stated on the cabinet serial data plate. For 
correct voltage, power draw, and wire accommodations, check the data on the 
serial data plate located on the inner right wall of your new model. Verify that this 
information exactly matches the electrical characteristics at the installation location. 
An electrical wiring diagram, located on the upper cabinet end panel next to the 
electrical console box, should also be consulted during connection. 
 

 The condensing unit supplied with all self-contained models is 

designed to operate with a voltage fluctuation of + 10 % of the voltage indicated on 
the cabinet serial data plate. Full voltage of the correct service, on an individual 
line not affected by the operation of other electrical appliances, must be available 
to the condensing unit at all times. Burnout of the compressor due to 
exceeding the high or low voltage limits is easily detected and will 
automatically void the factory warranty. 
 

All 115 volt models are provided with a U.L. approved power cord and polarized 
plug which is factory installed. 
   

 Any alterations to this cord and plug could cause an electrical 

hazard and will void the factory warranty. 
To insure proper operation, this equipment must be plugged into a NEMA 5-15R 
compatible, grounded receptacle that can supply the full voltage as stated on the 
serial data plate. 
 

All 208-230 volt models are to be permanently connected and are provided with 
four (4) field wiring leads which exit the electrical console box located in the 
machine compartment behind the front grill. The cabinet circuitry is 115 volts and 

 

- 9 -