Graco PR70 Manual De Usuario

 

312393G 

 

11 of 50 

 

1.  At any time and from any screen, to immediately 

disable all machine motion, press 

 (red)

. 

2.  If activated, the purge timer will be disabled

 

3.  To resume operation, the machine must be put 

back into an operating mode as described in the 
Machine Mode Selection section.  

4.  If activated, the purge timer will not restart until a 

shot is taken. 

Before the machine will operate properly, it must be 
calibrated and shot size information must be entered. 

1.  From the Run screen press 

.  If no password 

has been programmed into the HMI, the 
Programming Mode Selection Screen (Figure 7) 
will be displayed.   

 

2.  To enter the calibration screens, press 

.  To 

enter the maintenance screens, press 

.  Refer 

to Figure 9 for a screen navigation diagram. 

1.  From the Run screen press 

.  If a password has 

been programmed, the Password Entry Screen 
(Figure 8) will be displayed.   

 

2.  Enter the 6 digit password by pressing the 

corresponding soft keys, G-J in Figure 5. 

3.  After the 6

th

 digit has been entered, press 

.   

4.  If the correct password has been entered, the 

Programming Mode Selection Screen will be 
displayed.  Refer to Figure 9 for a screen navigation 
diagram. 

5.  If the incorrect password has been entered, the 

password entry will need to be repeated until the 
correct 6-digit sequence is entered. 

6.  To abort the password entry, press 

.