Graco PR70 Manual De Usuario

 

312393G 

 

7 of 50 

Accessories are available from Graco.  Make certain all 
accessories are adequately sized and pressure-rated to 
meet your system needs.   

Figures 2 thru 4 are only a guide for identifying system 
components and for assisting in installation.  Contact 
your Graco distributor or Graco Ohio Customer Service 
for assistance in designing a system to suit your 
particular needs. 

1.  Inspect the shipping container carefully for damage.  

Contact the carrier promptly if there is damage. 

2.  Open the box and inspect the contents carefully.  

There should not be any loose or damaged parts in 
the container. 

3.  Compare the packing slip against all the items in 

the box.  Report any shortage or other inspection 
problems immediately.   

4.  Remove the PR70 system components from the 

container.  Do not lift the machine by the tanks. 

1.  Locate a bench top or equivalent location to 

mechanically mount the PR70 dispensing machine.  

Verify the location has access to compressed air, 
AC power and is well ventilated. 

2.  Place the PR70 onto the designated location.  Allow 

to the machine to rest on the rubber feet provided. 

3.  Turn the Shield Locking Screws clockwise on both 

sides to remove the PR70 protective shield. 

4.  Attach the PR70 frame to the selected location by 

installing fasteners (not provided with unit) thru the 
4 mounting holes.  Refer to Figure 1 for mounting 
hole dimensions. 

 

 

 

 

Avoid contact with electrical inter-connects, when connecting electric 
power to the machine.  Read all manufacturer’s warning and material 
MSDS to know the specific hazards of the material used.   

1.  Connect a compressed airline to the input air in the 

back of the machine.   

2.  Load material into the on-board or off-board tanks 

feeding the machine. 

3.  Using the power cord provided, connect AC power 

(100-240V, 50/60 Hz, single-phase) to the machine.