GE IM-6 Manual De Usuario

Loosen the two mounting screws (B) but do not
screw them all the way out. If your model does not
have the screws already in the freezer wall, look for
two plug buttons. Remove the plug buttons and
insert the two Phillips head screws (14). The screws
should extend approximately 1/2

″ (13 mm) out from

the freezer wall.

• Remove and discard the white plug from the 

upper left corner of the freezer wall.

• Cut the fill tube extension (10) to the 

length

(refer to the 

template on page 67) with a 

sharp knife or a single-edge razor blade and 
slide it onto the fill tube against the stop.

Unplug the

Refrigerator. To eliminate the danger 
of electric shock during installation,
you must unplug the refrigerator 
from its electrical outlet.

Flat blade and Phillips

screwdrivers

Pliers

Sharp knife

Remove 
plug

Set the icemaker power switch to OFF. Leave 
the power switch in the OFF position until the
refrigerator is connected to the water supply to 
prevent premature operation.

Remove the electric plug cover from
the left side wall of the freezer by
pulling the cover (A) straight out 
while pressing the sides of the cover 
to free its tabs from the slots. Discard
the cover.

If the refrigerator already has a water tube inlet
on the back of the refrigerator, go to Step 2.
• Cut the fill tube (16) to the 

length (refer to

the 

template on page 66),

with a sharp knife or a single-
edge razor blade.

• Slide the fill tube (16) onto

the water tube inlet (15).

• Find the small label in the

upper right hand corner on the back of the
refrigerator. Peel off the label.

• On the tube side of the

water tube inlet (15) there 
is an adhesive backing.
Remove the adhesive
backing and slide the 
tube into the hole near 
the top at the back of the refrigerator. 
Firmly press on the inlet to secure it.

Power
Switch

Hole for
wire tie