GE IM-6 Manual De Usuario

Unplug the

Refrigerator. To eliminate the danger 
of electric shock during installation, 
you must unplug the refrigerator 
from its electrical outlet.

Flat blade and Phillips

screwdrivers

Pliers

Sharp knife

• Remove and discard the large white plug from 

the rear freezer wall. Pull out the gray insulation
plug and remove any debris.

• Remove the two small white plug buttons on the side

wall. Install two Phillips head screws (14) in the holes
that the plug buttons were in, but do not screw them 
all the way in. The screw heads should extend about
1/2

″ (13 mm) from the side wall of the freezer.

• Remove the outlet cover with a flat-blade

screwdriver.

Set the icemaker power switch to OFF. Leave 
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.

• Cut the fill tube (16) to the 

length (refer to the 

template

on page 66) with a sharp knife 
or a single-edge razor blade.

• Slide the fill tube (16) onto the

water tube inlet (15).

• Go to the back of the refrigerator. In the upper right

hand corner, remove the label covering the hole. Pull
out the insulation plug and any debris.

• On the tube side of the

water tube inlet (15) there 
is an adhesive backing.
Remove the adhesive
backing and slide the 
tube into the hole near 
the top at the back of the refrigerator. Firmly press
on the inlet to secure it to the refrigerator.

Power
Switch

Hole for
wire tie