GE IM-6 Manual De Usuario

Flat blade and Phillips

screwdrivers

Pliers

Sharp knife

Set the icemaker power switch to OFF. Leave 
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.

• Cut the fill tube (16) to the 

length (refer to the

template

on page 66) with a sharp knife 
or a single-edge razor blade.

• Slide the fill tube (16) onto the

water tube inlet (15).

• Go to the back of the refrigerator. In the upper 

right hand corner, remove the label covering the 
hole. Pull out the insulation plug and any debris.

• On the tube side of the 

water tube inlet (15) there 
is an adhesive backing.
Remove the adhesive 
backing and slide the tube
into the hole near the top at
the back of the refrigerator. Firmly press on the 
inlet to secure it to the refrigerator.

• Remove and discard the large white plug or foil

sticker from the rear freezer wall. Pull out the 
gray insulation plug and remove any debris.

• Loosen the two mounting screws but do not 

screw them all the way out. The screws should
extend approximately 1/2

″ (13 mm) out from 

the freezer wall.

• Remove the outlet cover with a flat-blade

screwdriver.

Unplug the

Refrigerator. To eliminate the danger 
of electric shock during installation, 
you must unplug the refrigerator 
from its electrical outlet.

Power
Switch

Hole for
wire tie