GE IM-6 Manual De Usuario

• Inside the freezer, remove the two small white plug

buttons from the side wall.

• Using the Phillips head screws

that are with the mounting
block, attach the mounting
block to the refrigerator by
driving the screws through the outer holes on 
the block and into the holes that the plug buttons 
were in.

• Install two self-tapping Phillips head screws (14) 

from the kit in the inner holes on the mounting block.
On some models, the screws may already be in 
place on the mounting block. The screw heads 
should extend about 1/2

″ (13 mm) from the 

mounting block.

Unplug the

Refrigerator. To eliminate the danger 
of electric shock during installation, 
you must unplug the refrigerator 
from its electrical outlet.

Flat blade and Phillips

screwdrivers

Pliers

Sharp knife

Ice bucket

Part No. WR30S1

Icemaker mounting block

Part No. WR2M3604

Set the icemaker power switch to OFF. Leave 
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.

• Cut the fill tube (16) to the 

length (refer to the 

template

on page 66) with a sharp knife 
or a single-edge razor blade.

• Slide the fill tube (16) onto the

water tube inlet (15).

• Go to the back of the refrigerator.

Remove the label covering the 
hole. Pull out the insulation plug 
and any debris.

• On the tube side of the water 

tube inlet (15) there is an 
adhesive backing. Remove the
adhesive backing and slide the 
tube into the hole near the top at the back of the
refrigerator. Firmly press on the inlet to secure it to
the refrigerator.

• Remove all freezer baskets for greater accessibility

to the rear of the freezer.

• Remove and discard the

large white plug from 
the rear freezer wall. 
Pull out the gray
insulation plug and
remove any debris.

• Remove the outlet cover

with a flat-blade screwdriver.

Phillips head

screws (2)

Part No. WR1M478

Power
Switch

Hole for
wire tie