U-Line CLR2060SSHR Manual De Usuario

11

Design 

■

Features 

■

Performance 

ÉCHELON™ DOOR ADJUSTMENT

All Échelon™ model doors are aligned at the factory before shipment. Occasional re-adjustment may be
necessary, especially if an Overlay Panel is installed. The following procedure will correct for up to 1/4"
alignment.

To adjust door:

1. Compare the top edge of the door (opposite the hinges) to the top edge of the cabinet and note the

type (up or down) of adjustment needed.

2.  Remove the top hinge pivot pin with a 7/64" hex wrench (see Figure 2) and lift door off bottom hinge

pin. Be careful not to lose door closer inserts (see Figure 5).

Note: The hinge plate on some Échelon™ models does not

3. With door upside-down, inspect the bottom hinge plate

mounting holes. 

a.  If your plate has slotted mounting holes, loosen 

but do not remove the two hinge plate screws.

b.  If your plate does not have slotted mounting 

holes, remove the old plate and install the new 
plate with the notch to the inside of the door 
(see Figure 3).

The door should never be flush with the top of the cabinet. Even when level, the top edge of 
the door will be 1/8" below the top of the cabinet (see Figure 1).

DOOR001

UL310