U-Line CLR2060SSHR Manual De Usuario
21
Design
■
Features
■
Performance
CO2075FF AND U-CO29FF ICE MAKER OPERATION
Note: The refrigeration system operates independently of the ice maker. This is a new design for U-Line.
All other U-Line ice makers use a double throw control system where the unit is either in a freeze
mode or harvest mode. In the CO2075FF and the U-CO29FF the refrigeration system will cycle on
and off depending on the temperature of the freezer. In most cases this means the refrigeration
system will be operating during the ice making and harvest modes. If the freezer control is set too
warm the refrigeration system may cycle off during ice making mode, slowing the ice production
rate. If this happens adjust the freezer control colder.
mode or harvest mode. In the CO2075FF and the U-CO29FF the refrigeration system will cycle on
and off depending on the temperature of the freezer. In most cases this means the refrigeration
system will be operating during the ice making and harvest modes. If the freezer control is set too
warm the refrigeration system may cycle off during ice making mode, slowing the ice production
rate. If this happens adjust the freezer control colder.
Ice Maker Operating Cycles
1. Freeze Cycle
A. Ice maker thermostat (located behind grille) open.
B. Freezer control closed and refrigeration system is operating.
B. Freezer control closed and refrigeration system is operating.
2. Harvest Cycle-1
A. Ice maker thermostat closed.
B. Refrigeration system operating.
C. If bin arm is up the harvest will not initiate.
D. Power goes through the bin switch to the ice maker motor and mold heater.
B. Refrigeration system operating.
C. If bin arm is up the harvest will not initiate.
D. Power goes through the bin switch to the ice maker motor and mold heater.
3. Harvest Cycle-2
A. Ice maker ejector blades reach 2:00 position and cam depresses the hold switch.
B. Ejector blades stall on ice and ice maker motor pulsates until mold heater warms and ice releases.
C. Refrigeration system operating.
B. Ejector blades stall on ice and ice maker motor pulsates until mold heater warms and ice releases.
C. Refrigeration system operating.
4. Water Fill Cycle
A. Ice maker blades reach approximately 10:00 position and cam depresses the water fill switch.
B. Power to the water valve. Ice maker mold fills.
C. Refrigeration system operating.
B. Power to the water valve. Ice maker mold fills.
C. Refrigeration system operating.
5. Eject Cycle
A. Ejector blades push ice into bucket and stop at 12:00 position.
B. Ice maker temperature control opens.
C. Refrigeration system still operating.
B. Ice maker temperature control opens.
C. Refrigeration system still operating.
CO2075FF/2075RF & U-CO29FF MODELS