U-Line ULN-95 Manual De Usuario

Note: The refrigeration system operates independently of the ice 

maker. This is a new design for U-Line. All other U-Line ice makers 

use a double throw control system where the unit is either in a 

freeze mode or harvest mode. In the U-CO29FF, the refrigeration 

system will cycle on and off depending on the temperature of the 

freezer. In most cases, this means the refrigeration system will be 

operating during the ice making and harvest modes. If the freezer 

control is set too warm, the refrigeration system may cycle off during 

ice making mode, slowing the ice production rate. If this happens, 

adjust the freezer control colder.

• Ice maker thermostat (located behind grille) open.
• Freezer control closed and refrigeration system is operating.

• Ice  maker  thermostat  closed.
• Refrigeration system operating.
• If bin arm is up, the harvest will not initiate.
• Power goes through the bin switch to the ice maker motor and 

mold heater.

Harvest Cycle - 2
• Ice maker ejector blades reach 2:00 position and cam depresses 

the hold switch.

• Ejector blades stall on ice and ice maker motor pulsates until 

mold heater warms and ice releases.

• Refrigeration system operating.

• Ice maker blades reach approximately 10:00 position and cam 

depresses the water fill switch.

• Power to the water valve. Ice maker mold fills.
• Refrigeration system operating.

• Ejector blades push ice into bucket and stop at 12:00 position.
• Ice maker temperature control opens.
• Refrigeration system still operating.