Multitech MTCBA-Xx-EN2 Manual De Usuario
Chapter 3 – Using the Web Management Software
62
MultiModem rCell User Guide
Configuring New Services
Before you configure the network, note the following:
●
A Service Name cannot be edited.
●
A Service cannot be deleted if it is used in another configuration.
●
Service changes are reflected in all the configurations in the Web Management software where they are used.
●
Services added here are displayed in the following sections: DNAT, Packet Filters.
To configure:
1.
For the new service, configure the following parameters:
Name:
Enter the name of the Service which is limited to 16 characters. It has to be unique.
Protocol:
Enter the type of protocol (TCP, UDP).
Source Port:
Enter the Destination Port for this service. The source and destination ports can be entered
either as a single port or a range using a colon as the separator.
Destination Port:
Enter the name of the Destination Port for the service.
2.
Click Add. The new service is added and appears on the page.
Packet Filters, Packet Filters Parameters
You can Delete or Edit a packet filter rule after it has been defined and added by using the table at the bottom of the screen.
Packet Filter Group
From (Host/Networks):
Enter the network/host from which the packet must originate for the filter rule to match.
The Any option, which matches all IP addresses regardless of whether they are officially assigned addresses or
private addresses, may also be entered. The network/host must be pre-defined in the Networks section.
private addresses, may also be entered. The network/host must be pre-defined in the Networks section.
Service:
Enter the service that is to be matched with the filter rule. These services must be pre-defined in the
Services section. These services precisely define the traffic to be filtered.
To (Host/Networks):
Enter the network/host to which the packet must send for the filter rule to match. The Any
option, which matches all IP addresses regardless of whether they are officially assigned addresses or private
addresses, may also be entered. The network/host must be pre-defined in the Networks section.
addresses, may also be entered. The network/host must be pre-defined in the Networks section.