Maytag AOES3030 Manual De Usuario

To avoid risk of electrical shock, personal injury, or
death, disconnect power to unit before servicing.

16

16021875  Rev. 0

©2003 Maytag Appliances Company

To avoid risk of personal injury or property damage
this unit requires a two man lift when lifting unit in or
out of cutout.

1. Turn off power to the oven at the circuit breaker.
2. Open oven door and remove screws securing unit to

the wall.

3. Pull the oven forward out of the cabinet opening.
4. Disconnect or unplug the power cord leading from

unit to fuse box or junction box depending on unit.

5. Replace the oven using the installation instructions.

1. Turn off power to unit.
2. Open oven door and remove screws securing unit to

the wall.

3. Slide unit approximately 6 inches out of wall cutout.
4. Remove screws securing control panel to unit,

located on the outer portion of trim.

5. Gently pull control panel forward to gain access to

wire terminals.

While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.

6. Disconnect and label wire terminals.
7. Reverse procedure to reinstall control panel.

1. Turn off power to unit.
2. See “Control Panel” for removal.

While unplugging electrical connections, pins may be
damaged, use extreme care when disconnecting.

3. Disconnect all electrical connection from E.R.C. unit.
4. Remove screws securing E.R.C. to control glass

panel.

5. Reverse procedure to reinstall E.R.C..

1. Turn power off to unit.
2. See “Control Panel” for removal.
3. Disconnect and label wire terminals.
4. Release plastic tabs securing circuit board to control

glass panel.

5. Reverse procedure to reinstall.

1. Turn power off to unit.
2. Open oven door and remove screws securing unit to

the wall.

3. Remove oven from cutout opening.
4. Disconnect or unplug the power cord leading from

unit to fuse box or junction box depending on unit.

5. Remove screws securing outer wrapper top cover to

outer wrapper cover.

6. Disconnect and label wire terminals connected to

limit switch.

7. Remove screws securing high limit switch.
8. Reverse procedure to reinstall switches.