Beko UFC524W Manual De Usuario

EN

8

1.  The appliance should be transported 

only in a vertical upright position. The 
packing as supplied must be intact 
during transportation.

2.  If during the course of transport the 

appliance has to be transported 
horizontally, it must only be laid on its 
right hand side when standing in the 
front of the appliance. After bringing 
it to upright position,it must not be 
operated for at least 4 hours to allow 
the system to settle.

3.  Failure to comply with the above 

instructions could result in damage 
occuring to the appliance. The 
manufacturer will not be held 
responsible if these instructions are 
disregarded.

4.  The appliance must be protected 

against rain, moisture and other 
atmospheric influences.

5.  Empty any water in the drain 

tray before moving see section 
“Defrosting” and “Cleaning & Care” 
for further information

IMPORTANT : Make sure the plastic 

evaporating pan at the back of the 
product collects water properly. 
IMPORTANT: Care must be taken 

while cleaning / carrying the appliance 
to avoid touching the bottom of the 
condenser metal wires at the back of 
theappliance as you might injure your 
fingers and hands.
IMPORTANT: This appliance is not 

designed for stacking with any other 
appliance.When positioning your 
appliance, take care not to damage 

your flooring, pipes,wall coverings etc. 
Do not move the appliance by pulling 
by the door or handle.Do not attempt 
to sit or stand on top of your appliance 
as it is not designed for such use. You 
could injure yourself or damage the 
appliance.
IMPORTANT: Make sure that 

mains cable is not caught under the 
appliance during and after carrying 
/ moving the appliance, to avoid 
the mains cable becoming cut or 
damaged.”Do not allow children to play 
with the appliance or tamper with the 
controls.
BEKO declines to accept any liability 
should the instructions not be followed.

1.  If possible avoid placing the appliance 

near cookers, radiators or in direct    
sunlight as this will cause the 
compressor to run for long periods. 
If installed     next to a source of heat 
or refrigerator, maintain the following 
minimum side clearances:

  From Cookers   2”   (50 mm)
  From Radiators  12” (300 mm)
  From Refrigerators or Larder Fridge        
1”   (25 mm)
2.  No gap is required at sides and top. 

See item 3 below to ensure a gap is 
obtained at the rear of the appliance. 
If a gap is available on side and 
top, retain it if possible as it would 
improve the air circulation around the 
appliance.