Masterbuilt 20020107 Manual De Usuario

1. Check the regulator to be certain it is in the OFF position before connecting to the gas cylinder. 
    Perform soapy water test before each use.

2. Open tank cylinder valve.

3. To start timer operation, push POWER button; both lights will blink once. 

4. Press START button; green light will remain on, allowing 15 minutes of gas 

flow. 

5. Turn regulator on.

6. Place a lit match to the burner from under the wind shield as shown below.  

7. Slowly turn regulator control knob clockwise until the burner lights.
 
•Timer will run 15 minutes before shutting gas flow off.  

•At 5 minutes remaining, gas flow light will blink slowly. At 2 minutes remaining gas flow light will 
 blink quickly.

•If burner does not light within 5 seconds, turn regulator control valve OFF, then turn gas cylinder valve 
 OFF. Wait 5 minutes for fumes to diminish, turn timer knob clockwise until its stops before relighting. 

•If the flame is blown out wait 5 minutes for fumes to diminish before resetting timer and relighting.

•After the burner is lit, open the regulator valve until the flame increases.  Use the air shutter on the 
 burner to adjust the flame until it turns blue. Reduce flame.

•Fill Pot with water or oil.  DO NOT fill pot more than 1/3 the pots full capacity.  This will help avoid 
 dangerous boil-overs. Note:  DO NOT place your empty pot over the open flame.  This will damage pot.

•Bring water or oil to the desired temperature by adjusting regulator control valve. Oil should never 
 exceed 400°F (204°C). Oil will ignite at 550°F (287°C) to 700°F (371°C).

•Always use a thermometer when frying.  

•After each use, first turn the regulator control valve OFF, then turn the gas cylinder OFF.  Always allow 
 fryer stand and pot with water or oil to cool completely before touching, moving, or storing.

Burner will not light

Not enough gas flow from propane 
tank

Open propane tank all the way

Low gas level in propane tank, or 
tank is empty 

Check gas level in propane tank

Blockage in burner 

Clean and check burner for spiders, 
insect nests, or other debris

Faulty 

burner 

    Contact Masterbuilt at 

1.800.489.1581

Hissing or gurgling sounds coming 
through gas  train from tank to
burner 

Water in burner

Check burner for moisture, make 
sure burner is dry

Damaged hose 

Perform soapy water test to check 
for cracks - See page 14

Gas leak 

Check all connections in gas train for 
possible leaks - See page 14

Timer does not work

Batteries are dead

Replace batteries - See page 11

Did not press power or start button

Follow  timer instructions - See page 
10

Faulty timer 

Contact Masterbuilt at 
1.800.489.1581

Timer stopped before time was up

Batteries are dead

Replace batteries - See page 11

Excessively yellow and irregular 
flame

Blockage in burner 

Clean and check burner for spiders, 
insect nests, and other debris.

Air damper not adjusted correctly 

Adjust air shutter to the burner until 
the burner flame is as blue as
possible - See page 9

Flame has gone out 

Low gas level in propane tank, or 
tank is empty 

Check gas level in propane tank

Too much wind

Check wind direction and set cooker 
away from windy areas - See page 3 

Blockage in burner

Clean and check burner for spiders, 
insect nests, and other debris

Water in burner

Check burner for moisture, make 
sure burner is dry

Faulty burner

Contact Masterbuilt at 
1.800.489.1581

LOW BATTERY

Basse Batterie

Batteria Baja

POWER

ENERGIA

PUISSANCE

GAS FLOW

Flujo el gas

Ecoulement de gaz

LIGHTING POSITION

FLAME VIEWING HOLE