Bunn Smart Wave Silver Series Manual De Usuario

Page 4

CAUTION - The brewer must be disconnected from the power source until specified in Initial Set-Up.

CAUTION – Improper electrical installation will damage electronic components.

1.  An electrician must provide electrical service as specified.

2.  Using a voltmeter, check the voltage and color coding of each conductor at the electrical source.

3.  If plumbing is to be hooked up later be sure the brewer is disconnected from the power source.  If plumbing 

has been hooked up, the brewer is ready for Initial Set-Up.

40410  022908

• This appliance must be installed in locations where it can be overseen by trained personnel.

• For proper operation, this appliance must be installed where the temperature is between 0°C to 35°C.

• Appliance shall not be tilted more than 10° for safe operation.

• An electrician must provide electrical service as specified in conformance with all local and national codes

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or 

mental capabilities, or lack of experience and knowledge, unless they have been given instructions concern-

ing use of this appliance by a person responsible for its safety.

• If the power cord is ever damaged, it must be replaced by the manufacturer or authorized service personel with 

a special cord available from the manufacturer or its authorized service personel in order to avoid a hazard.

Note: This electrical service consists of 2 cur-

rent carrying conductors (L1 and Neutral) and 

a separate conductor for chassis ground.

Note: This electrical service consists of 3 current 

carrying conductors (Neutral, L1 and L2) and a 

separate conductor for chassis ground.