Bunn RL00006929 Manual De Usuario

Page 4

CAUTION - Do not connect the brewer to the power source until specified in Initial Set-Up.

MODELS OL15 & 20 require 

2-wire, grounded service rated 

120 volts ac, 15 or 20 amp re-

spectively, single phase, 60 Hz.  

MODELS OL35 & RL35 require 

3-wire, grounded service rated 

120/208 or 120/240 volts ac, 20 

amp, single phase, 60 Hz.

Model OL15 has an attached cordset.

Models OL20, OL35, & RL35, proceed as follows:

CAUTION – Improper electrical installation will damage 

electronic components.

1. 

An electrician must provide electrical service as 

specified.

2.  Using a voltmeter, check the voltage and 

color coding of each conductor at the electrical 

source.

3.  Remove the top panel and rotate the control 

thermostat knob fully counterclockwise to the 

“OFF” position and replace the panel.

4.  Remove the rear panel, feed the cord through 

the strain relief, and connect it to the terminal 

block.

5.  Connect the brewer to the power source and 

verify the voltage at the terminal block before 

proceeding.  Replace the rear panel. 

 

6. 

If plumbing is to be hooked-up later be sure the 

brewer is disconnected from the power source.  

If Plumbing has been hooked-up, the brewer is 

ready for Initial Set-Up.

RL35B require 2-wire, ground-

ed service rated 240 volts ac 

or 200 volts ac, 20 amp single 

phase, 50 Hz.

MODEL OL25B requires 

2-wire, grounded service 

rated 100 volts ac, 20 amp 

single phase, 50 Hz.

32430 051512

200, 230 or

240V A.C.

• This appliance must be installed in locations where 

it can be overseen by trained personnel.

• For proper operation, this appliance must be installed 

where the temperature is between 5°C to 35°C.

• Appliance shall not be tilted more than 10° for safe 

operation.

• An electrician must provide electrical service as speci-

fied in conformance with all local and national codes.

• This appliance must not be cleaned by water jet.

• This appliance is not intended for use by persons 

(including children) with reduced physical, sensory or 

mental capabilities, or lack of experience and knowl-

edge, unless they have been given instructions con-

cerning use of this appliance by a person responsible 

for its safety.

• Children should be supervised to ensure they do not 

play with the appliance.

• If the power cord is ever damaged, it must be replaced 

by the manufacturer or authorized service personnel 

with a special cord available from the manufacturer 

or its authorized service personnel in order to avoid 

a hazard.

• Machine must not be immersed for cleaning.