Bunn VP17 Manual De Usuario

Page 3

 

This manual provides procedures for testing and 

replacing various major components used in this 

brewer should service become necessary.  Refer to 

Troubleshooting for assistance in determining the 

cause of any problem.
WARNING - Inspection, testing, and repair of electri-

cal equipment should be performed only by qualified 

service personnel.  The brewer should be unplugged 

when servicing, except when electrical tests are re-

quired and the test procedure specifically states to 

plug in the brewer.

COMPONENT ACCESS
WARNING - Disconnect the brewer from the power 

source before the removal of any panel or the replace-

ment of any component.
  All components are accessible by the removal of 

the top cover and front inspection panel and warmer 

assemblies.

The top cover is attached with one #4-40 screw.

The front inspection panel is attached with four #6-32 

screws.

The warmer assembly is attached with three #4-40 

screws.

Control Thermostat .............................................. 4

Limit Thermostat .................................................. 5

ON/OFF Switch ..................................................... 6

Tank Heater .......................................................... 7

Tank Heater Switch .............................................. 8

Warmer Elements............................................... 10

Wiring Diagrams ................................................ 11

P1160.40

46721  052512

FIG. 1 COMPONENT ACCESS