Bunn 38200.0016 Manual De Usuario

6. Cool the brewer by pouring a full decanter of fresh, cold water into the top of the

brewer. Place decanter on the base plate and close the lid. When water has stopped

flowing from the brewer, empty the decanter. Repeat this process and set the

decanter aside.

7. Grasp the back of the brewer and turn it upside down over a sink. Most of the water

in the tank will flow from the sprayhead tube opening. Some water may flow from the

area around the top lid. Continue tipping the brewer until the flow stops.

8. Pour a decanter of water into the top of the brewer. Place the decanter on the base

plate; close the lid and wait 3 minutes. Repeat this process with another decanter of

water. Water will flow out of the funnel after the second decanter has been poured in.

When flow from the funnel has stopped, empty the decanter and pour an additional

decanter of water into the brewer. Place the decanter on the base plate and close lid.

9. Replace the sprayhead and funnel. Pour additional decanters of fresh, cold water into

the brewer as needed until the water has no vinegar taste.

10. Place decanter on base plate and plug in the brewer. Allow the water in the tank to

reach brewing temperature before using (approximately 15 minutes).

THERMAL CARAFE ROUTINE CLEANING (BTX MODEL)

The carafe may be disassembled for cleaning. Rotate the lid

counterclockwise to remove. Occasionally, the brew through valve

should be removed and cleaned. Lift at the edge and pull up. Use

a mild, non-abrasive detergent to wash the lid thoroughly paying

particular attention to the passage where the brew through valve is located. After rinsing,

replace the brew through valve into the carafe lid. Do not use a scrub pad or other abrasive

cleaning device to clean the caraf , as this will scratch the stainless steel surface.

To remove coffee stains from inside the thermal carafe, place a paper filter in the funnel

and pour in two teaspoons of Cascade



powder dishwasher detergent into the paper

filter. Slide funnel onto the rails and open brewer lid. Pour one carafe of cold water

into brewer. Position carafe on base plate of brewer and close lid. When brewing cycle

has stopped, remove the brew funnel and discard the filter and detergent; rinse funnel

thoroughly. Allow carafe to sit for 10-15 minutes. Using a long handled, soft bristled

brush, clean inside of carafe as well as the outer rim to remove any coffee stains or

debris. Occasionally scrub the carafe pour lip and the area around it, including the lid,

with a mild detergent and warm water. Use a soft cloth and scrub hard. When finished,

pour out solution into sink and thoroughly rinse carafe and lid with clean water.

While cleaning your brewer, don’t forget to check your glass decanter
handle. If loose, use a standard screwdriver to tighten.

brew through valve

Did

you

know

Did you
kno

Us ed

S a b í a
U s t e d

u ave

V u