Smeg STA645Q Manual De Usuario
User instructions
12
3.2 Washing programs
Before starting a washing program make sure that:
•
The water supply tap is open.
•
The correct amount of detergent has been added to the
dispenser.
dispenser.
•
The baskets have been correctly loaded.
•
The spray arms are able to rotate freely and without
obstruction.
obstruction.
•
The dishwasher door is securely closed.
RAPID CYCLES (available in all programs except the soak program)
The rapid cycles option cuts the program duration but generates a slight
increase in water and electricity consumption. To activate this option,
press button (6) (light 7 comes on) after selecting the program required;
the option is automatically deactivated at the end of the program.
increase in water and electricity consumption. To activate this option,
press button (6) (light 7 comes on) after selecting the program required;
the option is automatically deactivated at the end of the program.
DELAYED START
(available in all programs except the soak program)
(available in all programs except the soak program)
The start of the program can be delayed by 3, 6 or 9 hours.
This allows you to set the dishwasher to work at the times of day most
convenient to you.
After setting the program of your choice, press the DELAYED START
button (8) to select the delay you require. The corresponding DELAYED
START light (9) lights up.
If you wish to exit the procedure without setting delayed start, press the
button in sequence until all three lights are out.
At the end of the cycle, the procedure is automatically deleted, so if you
also require it for the next program you will have to set it again.
This allows you to set the dishwasher to work at the times of day most
convenient to you.
After setting the program of your choice, press the DELAYED START
button (8) to select the delay you require. The corresponding DELAYED
START light (9) lights up.
If you wish to exit the procedure without setting delayed start, press the
button in sequence until all three lights are out.
At the end of the cycle, the procedure is automatically deleted, so if you
also require it for the next program you will have to set it again.