Glen Dimplex Home Appliances Ltd GT 755 Manual De Usuario
Green &
Yellow to
Yellow to
Earth
Brown to
Live
Electrical Connection
Connection to the electricity supply should be made via a properly earthed,
Legal Requirements
readily accessible wall socket which is adjacent to and not more than 1.25m
away from the appliance. The socket must be capable of electrical isolation.
away from the appliance. The socket must be capable of electrical isolation.
The mains lead should be routed such that it cannot touch hot parts of the
cooker i.e. the back panel above a height of 650mm from the floor.
Should this plug not fit the socket outlet in your home it should be cut off
and replaced with a suitable plug as outlined below.
and replaced with a suitable plug as outlined below.
IMPORTANT NOTE:
The severed plug cannot be used for any other appliance
and should therefore be properly disposed of in a safe manner. DO NOT
LEAVE where children might find it and plug into a supply socket - This is
an obvious hazard and extremely dangerous.
LEAVE where children might find it and plug into a supply socket - This is
an obvious hazard and extremely dangerous.
We recommend that the appliance is connected by a competent electrical
installer, who is a member of a recognised "competent persons" scheme
and who will comply with the I.E.E. and local regulations.
installer, who is a member of a recognised "competent persons" scheme
and who will comply with the I.E.E. and local regulations.
Where a fixed connections is used, a device allowing the appliance to be
isolated on all poles from the mains supply with a contact opening width of
at least 3mm must be provided.
isolated on all poles from the mains supply with a contact opening width of
at least 3mm must be provided.
This appliance must be earthed.
Important:
Ensure that you route all mains electrical cables well clear of any
adjacent heat source, such as an oven or grill.
If the Fitted Plug is
The flexible mains lead must be correctly connected as below to a three
Removed
pin plug of not less than 13amp capacity. If a BS 1363 plug is used, then
it must be fitted with a 3amp fuse approved to BS 1362.
it must be fitted with a 3amp fuse approved to BS 1362.
IMPORTANT: The wires in the mains lead fitted
to this appliance are coloured
in accordance with the following code:
Blue to
Neutral
GREEN AND YELLOW
- Earth
BLUE
-
Neutral
BROWN
- Live
Mains Lead Clamp
13 Amp Fuse
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:- The wire which is coloured green and yellow must be
connected to the terminal in the plug marked with the letter 'E' or by the
earth symbol or coloured k green or green and yellow. When connection
is completed, close the terminal block, ensuring the cover is engaged on
the locking tabs.
correspond with the coloured markings identifying the terminals in your plug,
proceed as follows:- The wire which is coloured green and yellow must be
connected to the terminal in the plug marked with the letter 'E' or by the
earth symbol or coloured k green or green and yellow. When connection
is completed, close the terminal block, ensuring the cover is engaged on
the locking tabs.
7