Genie 3024 Manual De Usuario

©2010     The Genie Company 

01/27/2010

19

– Controls door opener lights from inside garage
– Shuts OFF lights 4 minutes after door action

– LOCK disables controls  

 

  after door is completely    
 closed

– UNLOCK allows controls to  
  work normally

Indicator Light
Red indicator light is always ON

When Vacation Lock is ON the 
indicator light flashes

Open/Close Button
Open and closes door from inside garage

Use only the Series III wall console provided with this 
unit.  Wall consoles from other manufacturers will not 
work with this power head.  

Earlier Genie® 

Series II 

wall consoles will not work with this power head

.

Wall console has three buttons and one indicator light. 

Indicator light will display red when wall console 
is properly wired and Vacation Lock is OFF.  When 
Vacation Lock is ON indicator light flashes.

Use this button to open or close garage door.  When 
Vacation Lock is ON the Open/Close button will 
CLOSE door only.  Note: Constant button pressure in 
the CLOSE mode will override error responses in the 
power head and close door. 

Use this button to turn power head lights ON.  Power 
head lighting will remain ON until this button is 
pressed again or a door action has been completed.  
Note: If opener has a Motion Detector sensor the 
sensor will keep power head lights ON as long as 
motion is detected.

When Vacation Lock is ON the power head cannot be 
activated by the wall console or a remote.

•  Press and hold for 5 seconds (or till Indicator Light 

flashes) to activate Vacation Lock.

•  Press and release to turn Vacation Lock OFF. 

Use only the 

Series III 

wall console provided with this 

unit.  An optional second 

Genie® Series III 

wall console 

(not provided) can be added.  

W

B/W

W

B/W

W

B/W

W

B/W

Tip: If indicator light on wall console comes ON, but 
there is NO 
operation from 
buttons - 

verify 

wall console 
wire 

routing 

at power head 
connector. 

 

 

•   Observe all safety warning and precautions! 

Improper light bulb removal or replacement 
could result in Death or Serious Injury.

•   Disconnect power from opener before 

beginning this task.

•   When replacing light cover, make sure wires are 

not pinched or near moving parts.

1.  Disconnect power to door opener.

•  Open power head light cover.
•  Remove light bulb(s).
•  Replace with maximum 100 Watt light bulbs.

– Do NOT use light bulbs with greater than 100 

Watt rating.

•  Close power head light cover.

2.  Reconnect power to door opener.

•  Test light operation.