Genie 3024 Manual De Usuario

©2010     The Genie Company 

01/27/2010

5

1.  READ AND FOLLOW ALL SAFETY, INSTALLATION 

AND OPERATION INSTRUCTIONS.  (If you have 
questions or do not understand an instruction, call 
The Genie Company.)

2.  Install only on a properly balanced sectional or 

one piece garage door.  An improperly balanced 
door could cause severe injury.  Have a trained door 
system technician make repairs or adjustments to 
cables, spring assemblies, and other hardware before 
installing the opener.

3.  Remove all ropes and remove or make inoperative all 

locks connected to the garage door before installing 
opener.

4.  Where possible, install the door opener 7 feet or 

more above the floor.  For products having an 
emergency release, mount the emergency release 6 
feet above the floor.

5.  Do NOT connect the opener to source of power until 

instructed to do so.

6.  Locate the wall console:

•  Within sight of the garage door,
•  At minimum height of 5 feet so small children 

are not able to reach it, and

•  Away from all moving parts of the door.

7.  Install the Entrapment WARNING Label next to the 

wall console in a prominent location.

8.  After installing the opener, the door must reverse 

within 2 seconds when it contacts a 1-1/2 inch high 
object (or a 2 x 4 board laid flat) on the floor.

  OPENER MUST BE INSTALLED WITH THE INCLUDED 

WALL CONSOLE.

   Safe-T-Beam® SAFETY REVERSE SYSTEM MUST BE 

INSTALLED TO CLOSE DOOR.

1.  When garage door is opening, its movement will not be influenced if the Safe-T-Beam® is 

obstructed.

2.  If the Safe-T-Beam® is obstructed before the garage door fully closes, the door will not close.
3.  When the garage door is closing, if Safe-T-Beam® is interrupted by person or obstacle, the garage 

door will stop its downward travel and reverse automatically to its fully opened position.

4.  Remove Safe-T-Beam® obstruction.
5.  If the Safe-T-Beam® System fails, loses power, or is installed improperly, press and hold the wall 

console "open/close" button until the door reaches its fully closed position.  If you release the 
"open/close" button on the wall console during the closing movement the door will reverse 
automatically to its fully opened position.

OR CALL 1.800.354.3643 TO OBTAIN AN EMAIL PDF FILE

† Power head and rail are bolted to each other  (An illustration is shown on page 12)

(Example illustrations of the following items are shown on pages 10 and 11)

† Rail end is attached to the garage door header 

† Power head is attached to a support frame suspended from the ceiling or ceiling joists

† Rail door arm is attached to the garage door
† Safe-T-Beam® units installed and wired
† Wall console installed and wired
† Door arm carriage is engaged to the chain or belt drive
† Power head is plugged into an approved power outlet