Chicago Electric 91814 Manual De Usuario
If the steps above do not solve the problem or if the repairs involved are too
complex, contact a qualified technician.
IMPORTANT!
Be CERTAIN to shut off the Plasma Cutter, and disconnect it from power and air before
adjusting, cleaning, or repairing the unit. A technician should discharge all capacitors before
performing any internal procedures.
performing any internal procedures.
Page 22
skU 91814
for technical questions, please call 1-800-444-3353
TROUBLEShOOTING
(CONTINUED)
The Amperage setting may be too high;
try cutting at a lowest setting possible for
the metal being cut.
try cutting at a lowest setting possible for
the metal being cut.
fAST NOZZLE WEAR
OR
ExCESSIVE SLAG fORMATION
Take into account the thickness and type
of metal to be cut before you start. Thin-
ner materials will typically require lower
amp settings.
of metal to be cut before you start. Thin-
ner materials will typically require lower
amp settings.
PROBLEMS
REDUCED
Disconnect the Torch Cables.
Disassemble the torch assembly and
inspect all internal components, as ex-
plained on page 13.
Disassemble the torch assembly and
inspect all internal components, as ex-
plained on page 13.
Replace any damaged or missing compo-
nents and reassemble carefully, following
the directions on page 13.
nents and reassemble carefully, following
the directions on page 13.
TORCh IN GOOD
CONDITION
DAMAGED
COMPONENTS fOUND
Air supply pressure may be inadequate:
a. Verify that the compressor is delivering
a. Verify that the compressor is delivering
at least 3.5 CfM @ 65 PSI to the tool.
b. The Regulator on the unit must be set
to at least 60 PSI.
These two problems have similar causes
and will often appear simultaneously.
The same diagnostic procedures and
remedies apply to both.
and will often appear simultaneously.
The same diagnostic procedures and
remedies apply to both.
PROBLEMS PERSIST AT
LOWEST PRACTICAL SETTING
REV 07/05