Multiquip GB2000 Manual De Usuario

PAGE 32 —GB2000 BALLOON LIGHT• OPERATION AND PARTS MANUAL — REV. #1 (02/25/14)

MAINTENANCE

REPLACING LAMP

1. Unzip the zipper at the bottom of the balloon and roll

the balloon up to expose the lamp. See Figure 22.

Figure 22. Exposing Balloon

2. Release the lamp guard hooks from the poles and

remove the two lamp guards. See Figure 23.

Figure 23. Removing Lamp Guard

DANGER

Never attempt to replace lamp in a wet place. The

possibility exists of electric shock.

WARNING

Always allow sufficient time for the lamp to

cool down before replacing. The possibility

exists of severe burns if hot lamp is

touched.

CAUTION

Always shutdown power source and remove balloon

assembly from mast when replacing a broken lamp.

Utmost care should be taken in handling broken lamp.

The possibility exists of serious injury from handling a

broken lamp.

BALLOON

ZIPPER

LAMP GUARD

LOCK HOOK

3. Press the tabs on the lamp holder and push up lamp

holder to release it from lamp. Do the same to the lower

lamp if necessary. See Figure 24.

Figure 24. Lamp Holder

4. Remove lamp from the lamp socket by turning lamp

counterclockwise. See Figure 25.

Figure 25. Removing Lamp

5. Install new lamp into socket and turn lamp in a

clockwise direction until tight. See Figure 26.

Figure 26. Installing New Lamp

LAMP HOLDER

LAMP

SOCKET

LAMP

SOCKET