Graco 257065 Manual De Usuario

Keep sprayer and all accesso-
ries clean and in good working 
order.

To avoid overheating motor, 
keep vent holes in shroud clear 
for air flow. Do not cover sprayer 
while spraying.

Check hose for damage every time you spray. Do 
not attempt to repair hose if hose jacket or fittings 
are damaged. Do not use hoses shorter than 25 ft 
(7.6 m). Wrench tighten, using two wrenches.

•

Always clean tips with com-
patible solvent and brush 
after spraying.

•

Tips may require replacement 
after 15 gallons (57 liters) or 
they may last through 60 gal-
lons (227 liters) depending on 
abrasiveness of paint.

•

Do not spray with worn tip.

When pump packings wear, 
paint will begin to leak down 
outside of pump. 
•

Replace pump packings at 
first sign of leaking or addi-
tional damage could occur. 

•

Purchase a pump repair kit 
and install according to 
instructions provided with 
kit.

•

Consult a Graco/M

AGNUM

 

authorized service center.

Protect the internal drive parts of this sprayer 
from water. Openings in shroud allow cooling of 
mechanical parts and electronics inside. If water 
gets into these openings, the sprayer could mal-
function or be permanently damaged.

ti9354a

ti9355a

ti2055a

ti9356a