Metrologic Instruments MS1690 Manual De Usuario
23
T
ROUBLESHOOTING
G
UIDE
The following guide is for reference purposes only. Contact a Metrologic
representative at 1-800-ID-Metro or 1-800-436-3876 to preserve the limited
warranty terms.
representative at 1-800-ID-Metro or 1-800-436-3876 to preserve the limited
warranty terms.
All Interfaces
MS1690 Series Troubleshooting Guide
Symptoms
Possible Causes
Solution
No power is being
supplied to the
scanner.
supplied to the
scanner.
Check transformer, outlet and
power strip. Make sure the cable
is plugged into the scanner.
power strip. Make sure the cable
is plugged into the scanner.
No LEDs, beep
or illumination
or illumination
No power is being
supplied to the
scanner from the host.
supplied to the
scanner from the host.
Some host systems cannot supply
enough current to power The
MS1690. A power supply may be
required.
enough current to power The
MS1690. A power supply may be
required.
The wrong
communication cable
has been used.
communication cable
has been used.
Check that the communication
cable matches the unit type and
scanner configuration.
cable matches the unit type and
scanner configuration.
There has been a
scanner configuration
failure.
scanner configuration
failure.
Contact a Metrologic service
representative, if the unit will not
hold the saved configuration.
representative, if the unit will not
hold the saved configuration.
Long Razz tone
on power up
on power up
There has been a
diagnostic failure.
diagnostic failure.
Contact a Metrologic service
representative, if the unit will not
function.
representative, if the unit will not
function.
Long Razz tone
when exiting
configuration
mode
when exiting
configuration
mode
There was a failure
saving the new
configuration.
saving the new
configuration.
Re-try to configure the scanner.
Contact a Metrologic Service
Representative if the unit will not
hold the saved configuration.
Contact a Metrologic Service
Representative if the unit will not
hold the saved configuration.
Long Razz tone
There is a scanning
mechanism failure.
mechanism failure.
Contact a Metrologic service
representative.
representative.
Short Razz tone
in configuration
mode
in configuration
mode
An invalid bar code
has been scanned.
has been scanned.
Scan a valid bar code or quit
configuration mode.
configuration mode.