Gateway ALR 8300 Manual De Usuario

50          Maintaining and Troubleshooting the Gateway ALR 8300 Server

The procedure for installing software and drivers is usually specific to the 
operating system you will run on the server. Here are some tips.

Installing the USB driver

To use a USB device, you must install the USB driver in a computer 
running Windows 95. A 3.5-inch disk labeled “Integrated Controller UATA 
files for Win 95” was shipped with your computer. You must use this disk 
to install the USB driver.

Start the computer.

Put the 3.5-inch disk labeled “Integrated Controller UATA files for 
Win 95” into the disk drive.

Open the 

 file and follow the instructions on screen.

After you have installed the USB driver, install the USB device by attaching 
it to a USB port on the rear panel. Check the device documentation for 
additional information to see if you must install software for the device.

Installing video drivers

The integrated video controller on the system board uses standard drivers 
provided with the system utilities diskettes. For those running Windows NT 
in particular, use the driver provided on the utilities diskettes (Cirrus Logic 
Windows NT 4.0 diskette) not those provided on the Windows NT 
installation CD-ROM. The drivers provided on the Windows NT CD-ROM 
may not function correctly.

Video driver installation varies depending on the operating system that you 
run on the server. Refer to the documentation for the operating system for 
specific instructions.

To Install the USB Driver

4081TL.book  Page 50  Tuesday, December 22, 1998  1:27 PM