Black Box KV3204A Manual De Usuario
724-746-5500 | blackbox.com
Chapter 4: Configuration
724-746-5500 | blackbox.com
Page 27
4.2.6 Miscellaneous functions
To refresh EDID information from the monitor
1 Enter the Configuration menu (see Section 4.1 for details).
1 Enter the Configuration menu (see Section 4.1 for details).
2 Press
F to enter the Functions menu
3 Press
2 and then Enter.
4 Press
E and then Enter to exit the menu and save changes.
To use the stored EDID information at the power up
When you engage this mode, the unit will not interrogate the video display during startup and will instead use the data that are
stored. To revert to interrogating the video display, use the F 2 function discussed above.
When you engage this mode, the unit will not interrogate the video display during startup and will instead use the data that are
stored. To revert to interrogating the video display, use the F 2 function discussed above.
1 Enter the Configuration menu (see Section 4.1 for details).
2 Press
F to enter the Functions menu
3 Press
3 and then Enter.
4 Press
E and then Enter to exit the menu and save changes.
To reset configuration to factory defaults
1 Enter the Configuration menu (see Section 4.1 for details).
1 Enter the Configuration menu (see Section 4.1 for details).
2 Press
F to enter the Functions menu
3 Press
8 and then Enter. The display will show
r
momentarily.
4 Press
E and then Enter to exit the menu and save changes.
To show the current firmware version
1 Enter the Configuration menu (see Section 4.1 for details).
1 Enter the Configuration menu (see Section 4.1 for details).
2 Press
F to enter the Functions menu
3 Press
1 and then Enter.
The display will blank for a short while and then the major number of the firmware revision will be shown. The display will
blank again and then show the first digit of the minor number. Following another blank, the second digit of the minor number
will be displayed. e.g.
will be displayed. e.g.
<blank> 1 <blank> 0 <blank> 2 <blank> equals v1.02
4 Press
E and then Enter to exit the menu and save changes.
To set a new password
1 Enter the Configuration menu (see Section 4.1 for details).
1 Enter the Configuration menu (see Section 4.1 for details).
2 Press
P and then Enter. The display will show
3 Enter a new password and then
Enter. See 5.2 Locking Access to the Computers.
4 Press
E and then Enter to exit the menu and save changes.