Sony 8000SF Manual De Usuario

204

Setup

   

Cha

Copy (Tally Copy)
Copy the tally information pertaining to a particular source to a different 
source.
These settings are common to the parallel tally and serial tally.

Parallel port settings (Parallel Tally)
Make the parallel port settings for output of tally information pertaining to 
sources and destinations.
For each of the tally output terminal numbers, specify the tally type, and source 
address or destination level and address.

Serial tally settings (Serial Tally)
Make the serial tally settings, including tally type and source address for each 
serial tally port.

To connect the MKS-8080/8082 AUX Bus Remote Panel to a CCP-8000 
Center Control Panel using an S-Bus data link requires a BKPF-R70A Routing 
Switcher Controller Board or similar primary station and various settings for 
connection.
However, using a simple connection, the need for an S-Bus data link primary 
station is avoided, and direct connection to the MKS-8080/8082 is possible.
A simple connection is possible if the following conditions are met:
• There are no devices other than the CCP-8000 and MKS-8080/8082 

connected on the S-Bus data link.

• There are no more than 16 MKS-8080/8082 units connected on the S-Bus 

data link.