SMC Networks 10/100 Manual De Usuario
VLAN C
OMMANDS
3-129
switchport allowed vlan
Use this command to configure VLAN groups on the selected
interface. Use the no form to restore the default.
interface. Use the no form to restore the default.
Syntax
switchport allowed vlan {add vlan | remove vlan}
no switchport allowed vlan
no switchport allowed vlan
• add vlan - VLAN identifier to add.
• remove vlan - VLAN identifier to remove.
Do not enter leading zeros. (Range: 1-4094)
Default Setting
All ports are assigned to VLAN 1 by default.
The default frame type is untagged.
The default frame type is untagged.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• If switchport mode is set to trunk, then you can only assign an
interface to VLAN groups as a tagged member.
• Frames are always tagged within the switch. The tagged/
untagged parameter used when adding a VLAN to an interface
tells the switch whether to keep or remove the tag from a frame
on egress.
tells the switch whether to keep or remove the tag from a frame
on egress.
• If none of the intermediate network devices nor the host at the
other end of the connection supports VLANs, the interface
should be added to these VLANs as an untagged member.
Otherwise, it is only necessary to add at most one VLAN as
untagged, and this should correspond to the native VLAN for
the interface.
should be added to these VLANs as an untagged member.
Otherwise, it is only necessary to add at most one VLAN as
untagged, and this should correspond to the native VLAN for
the interface.
• If a VLAN on the forbidden list for an interface is manually
added to that interface, the VLAN is automatically removed
from the forbidden list for that interface.
from the forbidden list for that interface.