SMC Networks 10/100 Manual De Usuario
S
WITCH
M
ANAGEMENT
1-14
also provides a facility to upload firmware files to the system
directly through the console port. See “Upgrading Firmware via
the Serial Port” on page B-1.
directly through the console port. See “Upgrading Firmware via
the Serial Port” on page B-1.
Due to the size limit of the flash memory, the switch supports only
one operation code file, and two diagnostic code files. However,
you can have as many configuration files as available flash
memory space allows.
one operation code file, and two diagnostic code files. However,
you can have as many configuration files as available flash
memory space allows.
In the system flash memory, one file of each type must be set as
the start-up file. During a system boot, the diagnostic and
operation code files set as the start-up file are run, and then the
start-up configuration file is loaded. Configuration files can also be
loaded while the system is running; however, this will
automatically reboot the switch.
the start-up file. During a system boot, the diagnostic and
operation code files set as the start-up file are run, and then the
start-up configuration file is loaded. Configuration files can also be
loaded while the system is running; however, this will
automatically reboot the switch.
System Defaults
The switch’s system defaults are provided in the configuration file
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file (page 2-22).
“Factory_Default_Config.cfg.” To reset the switch defaults, this file
should be set as the startup configuration file (page 2-22).
The following table lists some of the basic system defaults.
Function
Parameter
Default
IP Settings
Management VLAN
1
IP Address
0.0.0.0
Subnet Mask
255.0.0.0
Default Gateway
0.0.0.0
DHCP
Disabled
BOOTP
Disabled
Web
Management
Management
HTTP Server
Enabled
HTTP Port Number
80