GarrettCom Magnum 6K32T Manual De Usuario

Magnum 6K32 & 6K32T Managed Switch                 Installation and User Guide (12/05) 

 

29 

.

.

Powering the Magnum 6K32T Managed Switch 

 

The Magnum 6K32T Switches incorporate an internal universal power supply 

and have a recessed male IEC connector for the AC power cord at the left-rear.  A 

manual power ON-OFF switch is adjacent. A six-foot 115 VAC 60 Hz standard power 

cord is supplied with each unit shipped within the United States and Canada.         

 

The auto-ranging power supply supports installation environments where the 

AC voltage is from 90 to 260 volts with a power input frequency between 47 and 63 Hz.  

The 32-port units will consume over 30 watts of power typically.  When connecting the 

Ethernet cabling, there is no need to power down the unit.  Individual segments can be 

connected or disconnected without concern for AC power-related problems or damage to 

the unit. 

 

Power supply options are available to suit the 6K32T Switches to special high-

availability communications and/or heavy industrial-grade applications, including: 

   *    -48VDC, 24VDC and 125VDC with single DC input, 

   *    -48VDC, 24VDC and 125VDC with dual-source DC input, 

See the Appendices of this manual for more details.  Use an RFQ for other variations. 

The Alarm Contacts feature, optional on Magnum 6K32T’s, provides two 

Form C Normally Closed (NC) contacts to which the user can attach two sets of status 

monitoring wires at the green terminal block. When this option is present, the terminal 

block for Alarm Contacts is part of the Power Input panel in the Magnum 6K32T case. 

The AC or DC power input connection is in the same panel. A manual On-Off Switch for 

power to the unit is not available on 6K32T units with the Alarm Contacts option, as 

these two features occupy the same space in the case. 

The first NC Alarm Contact (top position) is a “Software Alarm”, operated 

by user settings in the MNS-6K software.  The user can disable the Software Alarm 

feature with a software configuration command if desired. When the Software Alarm is 

enabled, the Form C Normally Closed (NC) contact is held close during normal software 

operation. A user-defined software malfunction, such as an SNMP Trap or a Software 

Security violation or an S-Ring Fault, causes the contact to open and thus trigger an 

alarm in the user’s monitoring system 

The second (bottom position) NC Alarm Contact is held close when there is 

power on the main board inside of the 6K32T.  This provides a “Hardware Alarm” 

because the NC contacts will open when internal power is lost, either from an external 

power down condition or by the failure of the power supply inside of the Magnum 

6K32T Switch. Useful info. about Alarm contacts:  
1. There is four terminal block (1,2,3,4)provided next to AC/DC power supply  
2. The top two pins (1,2) are software operated 
3. The bottom two pins (3,4) are hardware operated