3com 4210 Manual De Usuario
3
IP A
DDRESS
C
ONFIGURATION
G
UIDE
IP Address
Configuration Guide
Configuration Guide
If you want to manage a remote Ethernet switch through network management
or telnet, you need to configure an IP address for the remote switch and ensure
that the local device and the remote switch are reachable to each other.
or telnet, you need to configure an IP address for the remote switch and ensure
that the local device and the remote switch are reachable to each other.
A 32-bit IP address identifies a host on the Internet. Generally, a VLAN interface on
a switch is configured with one primary and four secondary IP addresses.
a switch is configured with one primary and four secondary IP addresses.
Network Diagram
Figure 6 Network diagram for IP address configuration
Networking and
Configuration
Requirements
As shown in the above figure, the port in VLAN 1 on Switch is connected to a LAN
in which hosts belong to two network segments: 172.16.1.0/24 and
172.16.2.0/24. It is required to enable the hosts in the LAN to communicate with
external networks through Switch, and to enable the hosts in the two network
segments to communicate with each other.
in which hosts belong to two network segments: 172.16.1.0/24 and
172.16.2.0/24. It is required to enable the hosts in the LAN to communicate with
external networks through Switch, and to enable the hosts in the two network
segments to communicate with each other.
Applicable Products
Vlan -int1
172 .16 .1.1/24
172 .16 .2.1/24 sub
172 .16 .1.1/24
172 .16 .2.1/24 sub
172.16.1.0/24
172.16.1.2/24
172.16.2.0/24
172 .16.2.2 /24
Host A
Host B
Switch
Product series
Software version Hardware version
Switch 5500
Release V03.02.04
All versions
Switch 5500G
Release V03.02.04
All versions
Switch 4500
Release V03.03.00
All versions