Cisco Systems 1503 Manual De Usuario

 Using Your Hub Software 3-29

Management Configuration Commands

Use the commands in this section to configure community strings and trap managers, which 
are required when using SNMP.

IP Parameter Commands

Use the commands in this section to configure the Micro Hub 1503 with IP parameters. The 
hub must be configured with IP parameters to use SNMP, Telnet, and TFTP functions.

show ip configuration

Guest

Shows the current configuration for IP, as shown below:

Hub> show ip configuration

IP address: 10.10.10.10 

Subnet mask : 255.255.255.0

Gateway IP: 10.10.10.254

• IP address—Hub’s IP address.

• Subnet mask—Hub’s subnet mask (the host address bits used for routing 

traffic to the subnet).

• Gateway IP—Gateway used to pass trap messages from the hub to the 

management stations, for example, the IP address of a router on the same 
LAN as the hub.