SMC Networks SMC6752AL2 Manual De Usuario
C
ONFIGURING
THE
S
WITCH
3-76
Filtering Addresses for Management Access
You create a list of up to 16 IP addresses or IP address groups that are
allowed management access to the switch through the web interface,
SNMP, or Telnet.
allowed management access to the switch through the web interface,
SNMP, or Telnet.
Command Usage
•
The management interfaces are open to all IP addresses by default.
Once you add an entry to a filter list, access to that interface is
restricted to the specified addresses.
Once you add an entry to a filter list, access to that interface is
restricted to the specified addresses.
•
If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
•
IP address can be configured for SNMP, web and Telnet access
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
respectively. Each of these groups can include up to five different sets
of addresses, either individual addresses or address ranges.
•
When entering addresses for the same group (i.e., SNMP, web or
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
Telnet), the switch will not accept overlapping address ranges. When
entering addresses for different groups, the switch will accept
overlapping address ranges.
•
You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
must delete the entire range, and reenter the addresses.
•
You can delete an address range just by specifying the start address, or
by specifying both the start address and end address.
by specifying both the start address and end address.
Command Attributes
•
Web IP Filter – Configures IP address(es) for the web group.
•
SNMP IP Filter – Configures IP address(es) for the SNMP group.
•
Telnet IP Filter – Configures IP address(es) for the Telnet group.
•
IP Filter List – IP address which are allowed management access to
this interface.
this interface.
•
Start IP Address – A single IP address, or the starting address of a
range.
range.