SMC Networks SMC6752AL2 Manual De Usuario

3-98

CLI – The following example enables LACP for ports 1 to 6. Just connect 
these ports to LACP-enabled trunk ports on another switch to form a 
trunk.

Ports assigned to a common port channel must meet the following criteria:
•

Ports must have the same LACP System Priority.

•

Ports must have the same LACP port Admin Key.

•

However, if the “port channel” Admin Key is set (page 4-142), then the 
port Admin Key must be set to the same value for a port to be allowed 
to join a channel group.

Console(config)#interface ethernet 1/1

Console(config-if)#lacp

Console(config-if)#exit

.

.

.
Console(config)#interface ethernet 1/6
Console(config-if)#lacp
Console(config-if)#end
Console#show interfaces status port-channel 1

Information of Trunk 1
 Basic information:
  Port type:              100TX
  Mac address:            22-22-22-22-22-2d
 Configuration:
  Name:
  Port admin:             Up
  Speed-duplex:           Auto
  Capabilities:           10half, 10full, 100half, 100full 
  Flow control status:    Disabled
  Port security:          Disabled
  Max MAC count:          0
 Current status:
  Created by:             Lacp
  Link status:            Up
  Port operation status:  Up
  Operation speed-duplex: 100full
  Flow control type:      None
  Member Ports: Eth1/1, Eth1/2, Eth1/3, Eth1/4, Eth1/5, Eth1/6,
Console#