Q-Logic 16-Feb Manual De Usuario

4 – Installation
Powering Down a Switch

4-20

59021-06 A

D

10. Display the list of firmware image files on the switch to confirm that the file 

was loaded. Refer to the 

 for more 

information.

SANbox2 (admin) $>image list

11.

Unpack the firmware image file to install the new firmware in flash memory.

SANbox2 (admin) $>image unpack filename

12. If the new firmware is later than version 2.0, the new firmware can be 

activated without disrupting traffic. Enter the Hotreset command to perform a 
non-disruptive activation.

SANbox2(admin) $>hotreset

Simply unplugging the switch from the power source does not allow the switch to 
complete executing tasks and could lead to flash memory corruption. For this 
reason, open a Telnet session and use the Shutdown command to initiate an 
orderly shut down, then power down the switch. Refer to the 

.