Cabletron Systems STHI Manual De Usuario

Page 5-13

Figure 5-6.  SNMP Traps Screen

The SNMP Traps screen is used to provide the STHI with the IP addresses 
of remote management stations intended to receive SNMP traps, and to 
provide those stations with the community names they will need to access 
the STHI with SNMP requests.

Use these fields to set an IP Address for each workstation designated to 
receive trap alarms from the STHI.

SNMP protocol requires that all traps issued include an SNMP community 
name. This field holds the community name to be sent to the 
corresponding network device. Some network management systems 
make use of this community name when polling the STHI.

Setting the value in this toggle field to 

 enables the STHI to send SNMP 

trap messages to the corresponding device; 

 disables the same.

     STHI LOCAL MANAGEMENT                  Flash Image Version:  1.00.00       

                                  SNMP TRAPS

    Trap Destination   Trap Community Name                 Enable Traps