Oceanic GEO Manual De Usuario

126

Closely examine the threads of the Battery Hatch and

Housing for any signs of damage that might prevent

proper threading.

Closely examine the inside of the Battery Compartment for

any signs of corrosion indicating entrance of moisture into

the unit.

If corrosion is found, return the GEO to an Authorized

Oceanic Dealer, and DO NOT attempt to use it until it has

received factory service.

If moisture is found, it is best to have the unit inspected

and cleaned by an Authorized Oceanic Dealer.

If it is necessary to clean the Battery Compartment, flush it

and all components with a solution of 50% white vinegar

and 50% fresh water. Rinse with fresh water, and allow to

dry overnight or blow dry with a hair dryer set at no heat.

Battery Installation

Slide a new 3 volt type CR2430 Lithium Battery, negative

side down into the Battery Cavity. Slide it in from the Left

side (Fig. 120) and ensure that it slides under the contact

clip on the lower/right rim of the cavity.

Lightly lubricate the new Hatch O-ring with silicone grease

and place it on the inner rim of the Battery Hatch. Ensure

that it is evenly seated (Fig. 121).

Fig. 120 - BATTERY

INSTALLATION

Fig. 121 - BATTERY

HATCH O-RING