Genicom 3400e Manual De Usuario
Chapter 6— Using Test and Service Mode
C d 39
Helvetica CondensedHelvetica
64
EasyCoder 3400e Bar Code Label Printer User’s Manual
*FORMAT*
*FORMAT*
3XXXU.049
➤
➤
-X
Y
➤
+X
+Y
➤
Direction of media from printer
Origin (Ø,Ø)
Leading
Edge
Edge
Default X and Y origins: This illustration shows the default X and Y origins. You can
control the default X origin (top of form) with PrintSet or with the Test and Service DIP
switches. You can control the default Y origin with the DIP switches only.
control the default X origin (top of form) with PrintSet or with the Test and Service DIP
switches. You can control the default Y origin with the DIP switches only.
The default X origin is .25 centimeters (0.10 inch) (20 dot increments)
from the edge of the label. You can move the X origin forward or back 30
dot increments. The default Y origin is .13 centimeters (0.05 inch) (10 dot
increments) from the leading edge of the label. Each dot increment is 5
mil (0.005 inch).
from the edge of the label. You can move the X origin forward or back 30
dot increments. The default Y origin is .13 centimeters (0.05 inch) (10 dot
increments) from the leading edge of the label. Each dot increment is 5
mil (0.005 inch).
X Forms Adjust
When you move the X origin forward, the printer moves the top of form
away from the edge before printing the label information. When you move
the X origin backward, the printer moves the top of form closer to the
edge before printing the label information.
away from the edge before printing the label information. When you move
the X origin backward, the printer moves the top of form closer to the
edge before printing the label information.
To set the X forms adjust
1
Turn the On/Off switch to the off position.
2
Press and hold the Feed/Pause button while turning on the printer.
The printer prints out the hardware configuration label and then enters
Data Line Print mode.
Data Line Print mode.
3
In the top bank of the Test and Service DIP switches, turn on switches
1, 2, 3, and 4. See the next illustration.
1, 2, 3, and 4. See the next illustration.
To move the X origin forward, turn off switch 5.
To move the X origin backward, turn on switch 5.