OKI C610 Manual De Usuario
19
– C610/C711
User’s
Guide
4.
Adjust the rear stopper (a) and paper guides (b) to the size
of paper being used.
To prevent paper jams:
• Do not leave space between the paper and the guides and
• Do not leave space between the paper and the guides and
rear stopper.
• Do not overfill the paper tray. Capacity depends on the
type of paper stock.
• Do not load damaged paper.
• Do not load paper of different sizes or types at the same
• Do not load paper of different sizes or types at the same
time.
• Close the paper tray gently.
• Do not pull the paper tray out during printing (except as
• Do not pull the paper tray out during printing (except as
described below for the 2nd tray).
>
NOTES:
>
If you have two trays and you are printing from the 1st
(upper) tray, you can pull out the 2nd (lower) tray
during printing to reload it. However, if you are
printing from the 2nd (lower) tray, do not pull out the
1st (upper) tray. This will cause a paper jam.
>
For face down printing, make sure the face up (rear)
stacker (a) is closed (the paper exits from the top of
the printer). Stacking capacity is approximately 250
sheets for the C610 and 350 sheets for the C711,
depending on paper weight.
>
For face up printing, make sure the face up (rear)
stacker (a) is open and the paper support (b) is
extended. Paper is stacked in reverse order and tray
CAUTION!
C711 ONLY: IMPORTANT: Set paper size dial (c) to the
size of paper being used (A4 in the above example).