OKI 8810 Manual De Usuario

1. Push the sheet supports in and lift the sheet feed 

platform 

2. Lift the lock lever on the left tractor, then move 

the left tractor to set the desired left margin for 

printing.
• The ▼ mark on the gauge (1)—or the center of 

the diamond shaped hole (2)—represents the 

location of the center of the first character 

printed.

The movement of the left tractor is limited to 

ensure that the paper covers the paper out 

sensor. 

3. Push the lock lever down to lock the left tractor in 

place.

4. Lift the lock lever (1) on the right tractor (2) and 

move the tractor over to correspond to the width 

of the continuous forms you are using. Center the 

paper support (3) between the two tractors. 

5. Open both tractor covers and place the first three 

holes in the continuous forms paper over the pins. 

6. Close the tractor covers and fine tune the position 

of the right tractor until the holes in the paper are 

centered on the pins, then push back the right 

tractor lock lever. 

7. Lower the platform.

F5-03a.jpg

  

8480_2_crop.jpg

  

F5-04a.jpg

  

F5-05a.jpg

  

F5-06a.jpg

  

F5-06b.jpg

 

F5-07a.jpg