OKI 8c Plus Manual De Usuario
User’s Guide
37
English
Replacing Transfer Belt
The transfer belt assemby must be replaced after approximately
50,000 pages. When the belt needs replacing you will see a
message to this effect on the operator panel display.
50,000 pages. When the belt needs replacing you will see a
message to this effect on the operator panel display.
1.
Press the OPEN button and lift the top cover to its fully
upright position. This allows the drums to rise clear of the
belt.
upright position. This allows the drums to rise clear of the
belt.
3.
Remove the waste toner box (1) as described in the
preceding section.
preceding section.
4.
Lift the coloured handle (2) on the belt assembly and
withdraw the unit from the printer.
withdraw the unit from the printer.
5.
Locate the new belt unit into its guide rails (3) in the printer
and gently push it all the way in until it locks into position.
and gently push it all the way in until it locks into position.
2.
Lift the catch and open the left-hand side panel.
6.
Refit the waste toner box as described in the preceding
section.
section.
7.
Close the left-hand side panel.
8.
Close the top cover and press down firmly at both sides to
ensure that it locks down.
ensure that it locks down.
1
2
3