Samsung CLP-350 Guía Del Usuario

.9   

<Selecting and loading print media>

• Preprinted paper is paper that has some type of printing on it before it 

is sent through the machine (paper that has a preprinted logo at the 
top of the page, for example).

• Letterhead must be printed with heat-resistant ink that will not melt, 

vaporize, or release hazardous emissions when subjected to the 
machine’s fusing temperature of 180 °C (356 °F) for 0.1 seconds.

• Ink on letterhead must be non-flammable and should not adversely 

affect machine rollers.

• Forms and letterhead should be sealed in moisture-proof wrapping to 

prevent changes during storage.

• Before you load preprinted paper, such as forms and letterhead, verify 

that the ink on the paper is dry. During the fusing process, wet ink can 
come off of preprinted paper, reducing the print quality.

To print on preprinted paper:

Squeeze the paper length guide and slide it out to its full length.

Load letterhead in the tray, with the print side up and the top and 
short edge

 first. Adjust the guides to fit the edge of the paper stack.

When you print, set the paper source to Manual Feeder and the 
paper type to preprinted, and select the appropriate paper size in 
the software application. See Software section.

Press the Stop button on the machine to start feeding.

• Postcards, 3in by 5in (index) cards, and other custom-sized materials 

can be printed with your machine. The minimum size is 3in by 5in 
(76mm by 127mm) and the maximum size is 8.5in by 14in (216mm by 
356mm).

• Always insert the short edge into the tray first. If you want to print in 

landscape mode, make this selection using your software. Inserting 
these materials long edge first may cause a paper jam.

• Do not print on material smaller than 3in (76mm) wide or 5in (127mm) 

long.

• In the software application, set margins at least 4mm away from the 

edges of the material.

To print on card stock:

Squeeze the paper length guide and slide it out to its full length.

Load print material in the tray, with the print side up and the short 
edge first

. Adjust the guides to fit the length and width of the 

material.

If you do not press the button after a pause, the paper will 

be automatically fed into the machine. 

When you print, set the paper source to Manual Feeder and select 
the appropriate size and type in the software application. See 
Software section. 
If the size of your print material is not listed in the size box in the 
paper

 tab, click the custom button and set the size manually.

Press the Stop button on the machine to start feeding.