Citizen Systems iDP-3535 Manual De Usuario

iDP-3535 User’s Manual

 CITIZEN

15/38

4-4 Inserting / Removing the Paper Cover and Stacker

1) Inserting and removing the paper cover and the stacker as shown in Fig. 9, 10.
2) Capacity of stacker

The maximum size of fun-fold paper sheet  which can be stored in this stacker is 3 to
3.5 (W) x 6 (H) x 1.6 (D) inches.

Fig. 9

Fig. 10

4-5 Self Test Printing

Your printer has a built in self print function for purpose of checking print operation without the need
for any other external device.

Procedures for Actuating the Print Function
1) Be sure that a paper roll is properly loaded.
2) Confirm that the Ribbon cassette is properly installed and turn the power switch off.
3) Turn the power switch ON while pressing the LF switch, and release the LF switch after the self test operation

has begun.

In the above operation, the self print function will stop automatically when completed.
However, the self print function will not operate without paper.

4-6 Alarm and Paper Near-End Detection

This printer has the paper near-end sensor to stop the operation when the paper comes to near-end, sending out
both BUSY and FAULT signals. This status is indicated by the SEL / ALARM lamp blinking at an interval of 1.0
second.
If the printer goes alarm, the printer stops printing out and outputs FAULT signal – OFF-LINE state. This status
makes the SEL / ALARM lamp blink at an interval of 1/4 second.