Manualsbrain.com
  1. Manuales
  2. Marcas
  3. Viewsonic
  4. PJD7400W
  5. Manual De Usuario

Viewsonic PJD7400W Manual De Usuario

Descargar
Página de 82
Controlling the projector through a LAN 
environment
The projector supports Crestron® software. With correct settings for the LAN Control 
Settings menu, you can manage the projector from a computer using a web browser when 
the computer and the projector are properly connected to the same local area network. 
Configuring the LAN Control Settings
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector 
and the other end to the RJ45 port.
2.
Press MENU/EXIT on the projector or Menu on the remote control and then press 
/
 until the SYSTEM SETUP: Basic menu is highlighted.
3.
Press  
to 
highlight 
LAN Control Settings and press MODE/ENTER on the 
projector or ENTER on the remote control. The LAN Control Settings page is 
displayed.
4.
Press  
to 
highlight 
DHCP and press 
/
 to select On.
5.
Press  
to 
highlight 
Apply and press MODE/ENTER on the projector or ENTER 
on the remote control.
6.
Please wait for around 15 - 20 seconds, and then re-enter the LAN Control Settings 
page. The Projector IP Address, Subnet Mask, Default Gateway, and DNS Server 
settings will be displayed. Note down the IP address displayed in the Projector IP 
Address row.
•
If the Projector IP Address still does not appear, contact your network administrator.
•
If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, 
Default Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are 
properly connected and perform the procedures above again.
•
If you need to connect to the projector in its standby mode, set Power Saving to Off.
If you are in a non-DHCP environment:
1.
Repeat steps 1-3 above.
2.
Press  
to 
highlight 
DHCP and press 
/
 to select Off.
USB
LAN
RS 232
(An example of connection)
39