Black Box EncrypTight Enforcement Point (ETEP) Installation Guide Manual De Usuario

Installing the ET0010A

ETEP Installation Guide

27

The steps to perform for a typical installation are listed below.

 outlines the standard cables used with each port on the ETEP. The connector type listed 

indicates only what is required to connect to the ETEP port, and may or may not be the same connector 
type required for the other end of the cable. Some cables are supplied by Black Box and others are user-
supplied. 

Remove all product components from the shipping carton and compare the contents to the packing list. 
Keep all packaging in case it is necessary to return the unit. 

The ETEP is packaged with the standard items listed below. Additional cables, country-specific power 
cords, and other accessories can be ordered separately.

1 ET0010A 

●

Firmware and software is factory-installed on the unit. 

2 Accessory Kit 

●

(1) Power cable (US)

●

(1) Power supply 

1

Review the cabling requirements.

2

Unpack the shipping package.

3

Install the ETEP in a rack or on a solid surface.

4

Connect the cables.

5

Apply power to the ETEP.

Power receptacle

Power supply and power cable 

Black Box

RS-232 port

1.8 meter shielded null modem 

cable with an RJ45 connector at 

one end and a DB9 female 

connector at the opposite end. 

Black Box

Ethernet Management Port

Unshielded Category 5 straight 

through cable (UTP), RJ-45 

connector

Black Box

Aux1 port 

Not applicable. Port is not 

enabled in this release. 

Not applicable

Remote and Local ports

(2) Unshielded Category 5 

straight through cables (UTP), 

RJ-45 connector

a

a. The local, remote, and Ethernet management ports are auto-sensing for polarity. You can use shielded Category 5 

straight through cables or crossover cables when connecting to these ports.

User