ZyXEL Communications VSG1432-B101 Series Manual De Usuario
Chapter 7 Wireless
VSG1432-B101 Series User’s Guide
110
7.8 The Others Screen
Use this screen to configure advanced wireless settings. Click Network Settings
> Wireless > Others. The screen appears as shown.
> Wireless > Others. The screen appears as shown.
screen.
Figure 35 Network Settings > Wireless > Others
The following table describes the labels in this screen.
Table 21 Network Settings > Wireless > Others
LABEL
DESCRIPTION
RTS/CTS
Threshold
Threshold
Data with its frame size larger than this value will perform the RTS
(Request To Send)/CTS (Clear To Send) handshake.
(Request To Send)/CTS (Clear To Send) handshake.
Enter a value between 0 and 2347.
Fragmentation
Threshold
Threshold
This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2346.
between 256 and 2346.
Auto Channel
Timer
Timer
If you set the channel to Auto in the Network Settings > Wireless >
General screen, specify the interval in minutes for how often the ZyXEL
Device scans for the best channel. Enter 0 to disable the periodical scan.
General screen, specify the interval in minutes for how often the ZyXEL
Device scans for the best channel. Enter 0 to disable the periodical scan.
Output Power
Set the output power of the ZyXEL Device. If there is a high density of
APs in an area, decrease the output power to reduce interference with
other APs. Select one of the following: 20%, 40%, 60%, 80% or
100%.
APs in an area, decrease the output power to reduce interference with
other APs. Select one of the following: 20%, 40%, 60%, 80% or
100%.
Beacon
Interval
Interval
When a wirelessly networked device sends a beacon, it includes with it a
beacon interval. This specifies the time period before the device sends
the beacon again.
beacon interval. This specifies the time period before the device sends
the beacon again.
The interval tells receiving devices on the network how long they can wait
in low power mode before waking up to handle the beacon. This value
can be set from20ms to 1000ms. A high value helps save current
consumption of the access point.
in low power mode before waking up to handle the beacon. This value
can be set from20ms to 1000ms. A high value helps save current
consumption of the access point.